6PC Khan Tech Waterproof Landscape EZ Wire Connector for Low-Voltage Transformer

Description: Made of durable waterproof nylon plastic with machined terminal steel pins and zinc-coated Tooless installation, no splicing - add wire in seconds! Use with 12/14/16 gauge wire Lifetime warranty - completely reusable, innovative design compared to old push/pinch styles -----------Step 1：Split apart the wire for landscape light (A) about 1 inch, pass the wire through screw cap (B) and wire sleeve (C) until it reaches the end of the silicon seal 1 Step 2：Inset the group unit (ABCD) to the side-hole connector (E), make sure the ends of two lighting wire touch at right place by aligning flat side with the inner flat side on the side-hole connector (E) unit’s hole, tighten the screw cap(B). Note: by tightening the screw cap (B), it will make ensure the wire ends. closely contact the copper pin and seal. Step 3：Open the locker handle (H) by turning to arrow direction, put the main wire (G) into the silicon seal 2 (F); make sure you can see the two flat pin pier comes out through the two flat holes on the Silicon seal 2 Note: Use the thinner silicon seal (F) for 12AWG main wire and the thicker silicon seal for 14/16AWG main wire. Step 4：Make sure your transformer output is ON. Tightly turn the Locker handle (H) to closed direction. You will see the light just ON, so connection is set.

Price: 9.95 USD

Location: Abington, Pennsylvania

End Time: 2024-10-17T17:57:44.000Z

Shipping Cost: 4.95 USD