Carpathian Elm Burl wood veneer 9" x 10" with no backing raw veneer AAA grade

Description: Carpathian Elm Burl wood veneer 9" x 10" with no backing raw flitch veneer 1/42" thickness AAA quality grade. One piece per price. All pieces matching and in sequence. Pulled form bundle # 134. Other sizes and backed veneer are available. *First picture is a finished sample from similar veneer. Second picture is the actual bundle that we would pull each piece from. You get unfinished veneer as shown in second photo (white lines are bundle straps that hold bundle together). Trust the experience, knowledge, and reputation that has served the wood industry and novices since 1995. Some notes about raw veneers in burl form: 1) The white bands are strapping to hold the bundles together. 2) Holes and voids are common to this type of veneer and would need wood filler after lamination. Please review picture closely to see how much of this exists if any. 3) Pricing is per piece, not for the entire bundle. If you need more than one piece, we would give some type of discount based on the quantity. 4) Burls from the same bundle are typically used to lay out side by side and end over end to make larger pieces. They will match up reasonably well after being trimmed to square or rectangular forms and this is what is done to make bigger backed sheets that we also have. 5) Some knife marks (from slicing the tree "stump") may be visible that should sand off. About pictures: Most pictures have been temporarily wet on the lower portion of the veneer to show what the grain may look like when finish is added. Color adjustments have been made to show the color as best as is possible. It is impossible to get photos exactly correct in color, but we have made an effort to do so. Backed products come with complete application instructions that are simple and clear. For raw veneer or un-backed products, we suggest using the Internet to see what advice is available as opinions vary on the best way to handle that product. Below is general information for most of our products. Make sure you check the listing to see which applies to the above product in particular. Thickness: (will not always be exactly correct, but relatively close) Paper-backed veneers = 1/40” Wood-backed veneers = 1/25” Raw plain veneer with no backing = 1/32”-1/42” How to cut: generally cut with a razor/box knife or similar tools and some type of straight edge is typically used. How to apply: Paper-backed and wood-backed veneers are generally applied with contact cement. Raw plain veneer is applied with white or yellow wood glue and must have pressure applied while drying. How to finish: most any conventional finishing products can be used with veneer that is applied correctly. Disclaimer: Sometimes veneers have minor splits or tears in them. These are usually taped or repaired in some manner and shouldn’t impact overall quality or satisfaction. There may also be some minor wood filler used to fill cracks and other crevices that may exist. Wood products are rarely perfect and some consideration of that may be needed occasionally since this is a natural product and is rarely ever perfect. Some sanding is usually required before finishing to prepare the surface for a finish and occasionally to remove veneer tape, splice glue, or some other imperfection.

Price: 30 USD

Location: Louisville, Kentucky

End Time: 2024-02-26T19:03:22.000Z

Shipping Cost: N/A USD